Wrecker belongs to the special vehicle, the operation method of the special vehicle is still different from the conventional car, the wrecker can be divided into a tow two flat wrecker, tow crane joint wrecker, crane separation type wrecker three kinds, some customers recently called to consult the operation method of a tow two wrecker, today Xiaobian is reluctant to introduce it to you. 
Drive the wrecker to the appropriate position of the vehicle to be carried. The specific steps are as follows: 1. First, remove the winch clutch, pull out the steel cable to the vehicle to be carried, and hook the "j" line hook to the traction carabiners under the towed end of the vehicle to be carried. Then engage the clutch of the winch. Note that the number of coils left when pulling out the cable should not be less than 5. 2. The vehicle to be carried must be in neutral and let go of the parking brake of the vehicle to be carried. 3, control the winch lever, pull the car onto the platform, and control the J-hook on the steel cable distance from the winch greater than 0.4m. When the winch is under load, do not disengage the manual control clutch of the winch as this will damage the winch. Note: When using the hook to winch the accident car, for the car with the bottom chassis, be very careful not to damage the part of the trailer, so as not to cause unnecessary trouble. 4. When the loaded vehicle has been towed into place, tie the rear tire with a safety strap, and pull the loaded car diagonally on both sides of the back and fix it on the flat pull ring on both sides. Note: If the safety pull is broken, the safety strap should be wrapped around the sturdy parts of the car. If the safety bandage cannot be manually locked, the winch lever can be controlled to manipulate the winch pull to move the loading car forward a little so that the safety chain is properly tensioned. 5, flat plate wrecker, flat plate with a strap to fix the failure of the car, must be locked in the wheel or body four straps. 6. The strap ratchet must be in a closed state when it is locked. Note: nylon strap for a long time tension will appear loose phenomenon, operation should be regularly checked bandage tension, especially in the case of bad road conditions or more sudden braking, should be checked in time to avoid accidents. 7. Control the platform tilt joystick so that the tail of the platform is raised 0.15m from the ground. 8, control the platform tilt joystick, so that the platform forward to about 0.6m away from the front end of the ***, control the platform tilt joystick to make the platform back to the horizontal position. 9, the control platform glide lever, the platform is moved forward to the front end of the ***. 10. In order to prevent damage to the winch caused by the tension of the steel cable due to vibration in the next driving process, the front end of the car must be fixed with the other two safety chains in accordance with the above-mentioned method, and tensioning as much as possible. Load positioning and taut. 11, will be loaded car hanging first gear, pull the handbrake. 12. Check whether all safety chains or chains and connections are tight and tensioned. 13, after the completion of the above steps, that is, and follow-up work procedures. Step on the clutch of the road wrecker, release the force extractor, and the platform loading operation is completed For more information about our vehicles, please feel free to contact Ms. Lily. We will customize the truck according to your requirements.
Sales Manager: Lily+86-13177185858
