The hydraulic winch operation method of the wrecker is explained

There are many kinds of special vehicles, of which the wrecker is a more common one, and the scope of use is also more extensive, in addition to the trailer, cleaning the fault vehicle, can also participate in the rescue, the wrecker according to the structure is roughly divided into one tow two and tow crane two, the structure is different, the configuration is different, but no matter what kind of structure, hydraulic winch is the necessary configuration, Because the wrecker belongs to a special model, its operation has certain requirements, and the hydraulic winch as the main parts on the wrecker, its operation method is also very important, next we will take a tow two flat wrecker as an example to introduce the operation knowledge of the wrecker hydraulic winch.
2825e5f718a45f7f1bc3399cd577f48b

1. First start the vehicle, put the gear in neutral position, step on the clutch, and open the force taking device. Before the operation of the hydraulic winch, put the flat plate down first. During the process of putting down the flat plate, pay attention to the rear lift, and adjust the height of the rear lift according to the position of the flat plate to lower it to the appropriate position.

2. Remove the winch clutch, pull out the wire rope to the vehicle before the fault is cleared, hook the traction carabiners of the backloaded vehicles, and then combine the clutch of the winch, special attention is that when pulling out the wire rope, the number of remaining wire rope rings shall not be less than 5 rings.
3e10a6b5ec61d4b74a120a9f8223f3af

3. At this time, the faulty vehicle should be put into neutral, release the parking brake of the faulty vehicle, and then operate the winch operating lever, pull the faulty vehicle to the flat plate, and control the hook distance from the winch is greater than 40 cm, when the winch is under load, do not open the manual control clutch of the winch, which will damage the winch, for the low chassis of the car, the operation should be very careful, Avoid secondary damage to the vehicle.

4. After dragging the faulty vehicle onto the car, use the strap to fix the vehicle tire, after fixing the flat tail slowly rise, about 15 cm from the ground, move the flat forward to 60 cm from the front end, and then adjust the height of the flat to the horizontal position, and finally move the flat to the front end.

5. Pull the parking brake of the faulty vehicle on, the gear is in the first gear position (automatic gear is in the P gear position), check whether the binding is secure, pay attention to the details of the inspection, after the inspection is correct, step on the wrecker clutch, turn off the force collector, and the faulty vehicle is loaded.

The above is the operation knowledge of the hydraulic winch of the flat wrecker, and I hope to give you help with it.